The Normally problems in daily maintenance of mini excavator,mini digger,rhino xn08 excavator,mini bagger etc.
The miniescavatore kingway first gear drive is weak, and other gears are normal / www.haiqinmachinery.com
First, the first gear drive must be weak. The miniescavatore kingway reason for these phenomena is that the first gear piston ring is scratched or worn too much,
resulting in excessive leakage of pressure oil, miniescavatore kingway which makes the first gear drive weak; In addition, the O-ring outside the first gear oil cylinder may be damaged, miniescavatore kingway resulting in a large amount of pressure oil leakage; If the fault is caused by the above reasons, the mini excavator gearbox must be lifted out, disassembled and replaced with mini bagger damaged piston rings and sealing rings; If mini bagger the variable speed mini bagger pressure gauge does not depressurize at the first gear position, it is mini bagger likely that the variable speed pull rod is not adjusted in place, which mini bagger makes the first gear drive weak. mini bagger Readjust the variable speed pull rod to make it mini excavator reach the specified position.
miniescavatore kingway check the pressure of the rhino xn08 excavator transmission gauge and rhino xn08 excavator whether there is pressure reduction in the first gear position. If the pressure is below 98.1kpa,