The hank telehandler company will determine the partners of these spare parts. Each factory will take back the spare parts after being approved by the factory director as needed during vehicle maintenance. The retrieved spare parts must go through warehousing procedures in the manitou forklift factory warehouse, and give the delivery note issued by the merchant to the storekeeper. At the end of each month, the storekeeper will sort out the delivery note, the warehousing note and the application form together, and then give them to the factory cashier, The cashier of each factory shall check and settle with the merchant based on the delivery note, and submit the invoice or receipt after settlement, together with the warehousing form and application form, to the company for approval before reimbursement. The main parts can only be taken with signatures of these cooperative merchants, and it is strictly prohibited to choose merchants to buy them. General parts are parts with a single value of less than 199 yuan.irst check whether the transmission is short of oil and whether the oil inlet pipeline is blocked,
and then check the telehandler t3007 transmission oil pan (electrical motor) and torque converter filter. If metal fragments are found,
it is certain that the cpd-5 telehandler parts in the large overrunning clutch in the transmission are damaged. If aluminum chips are found in the transmission
oil pan and torque converter filter, it is certain that the parts in the torque converter are damaged. At this time, the transmission and torque
converter must be disassembled and inspected for repair and replacement of damaged parts. If the above reasons are eliminated and the vehicle still
cannot walk, everun ert 1500 can be determined that the bolts around the second gear component in the gearbox are cut off, or the output gear of the intermediate shaft falls off, so that the power cannot be output. Troubleshooting: disassemble the 8-shaped end cover of the gearbox, take out the second gear component, and replace the cut-off bolt. The teleskoplader radlader bolt material is 40Cr, which must be quenched and tempered, and can never be replaced by ordinary bolts.
www.haiqinmachinery.com
www.haiqinloader.com